Stannic oxide
Stannic oxide structure
|
Common Name | Stannic oxide | ||
|---|---|---|---|---|
| CAS Number | 18282-10-5 | Molecular Weight | 150.71 | |
| Density | 6.95 g/mL at 25 °C(lit.) | Boiling Point | 1800-900°C | |
| Molecular Formula | SnO2 | Melting Point | 1127 °C | |
| MSDS | Chinese USA | Flash Point | 1800-1900°C | |
|
Correlation between emission property and concentration of Sn2+ center in the SnO-ZnO-P2O5 glass.
Opt. Express 20(25) , 27319-26, (2012) The authors report on the correlation between the photoluminescence (PL) property and the SnO amount in SnO-ZnO-P2O5 (SZP) glass. In the PL excitation (PLE) spectra of the SZP glass containing Sn2+ emission center, two S1 states, one of which is strongly affe... |
|
|
Growth of a Novel Nanostructured ZnO Urchin: Control of Cytotoxicity and Dissolution of the ZnO Urchin.
Nanoscale Res. Lett. 10 , 441, (2015) The applications of zinc oxide (ZnO) nanowires (NWs) in implantable wireless devices, such as diagnostic nanobiosensors and nanobiogenerators, have recently attracted enormous attention due to their unique properties. However, for these implantable nanodevice... |
|
|
Synthesis, structure and gas-sensing properties of Pd-functionalized ZnSnO3 rods.
J. Nanosci. Nanotechnol. 13(1) , 533-6, (2013) ZnSnO3 one-dimensional (1D) strutures were synthesized by using an evaporation technique. The morphology, crystal structure, and enhanced sensing properties of the ZnSnO3 structures functionalized with Pd to CO gas at 300 degrees C were investigated. The diam... |
|
|
SnO2-microtube-assembled cloth for fully flexible self-powered photodetector nanosystems.
Nanoscale 5(17) , 7831-7, (2013) Integrating an energy conversion or storage device with photodetectors into a self-powered system provides a promising route to future devices aimed at reduced size, low weight and high flexibility. We reported here the fabrication of a fully flexible self-po... |
|
|
Application of solution-processed V2O5 in inverted polymer solar cells based on fluorine-doped tin oxide substrate.
J. Nanosci. Nanotechnol. 14(6) , 4214-7, (2014) We used a hydrothermal method to synthesis the solution-processed V2O5 as anode buffer layer, which applied on inverted polymer solar cells based on FTO substrate. The structure of the device is glass/FTO/TiO2/P3HT:PCBM/V2O5/Ag. We discussed the dependence of... |
|
|
Morphological studies of SnO2 thin films fabricated by using e-beam method.
J. Nanosci. Nanotechnol. 13(5) , 3446-50, (2013) This paper studies the variations in morphology of SnO2 nanostructures thin films deposited by using e-beam technique with the substrate temperature, oxygen partial pressure and the film thickness. The e-beam conditions were optimized to get crystalline nanos... |
|
|
X-ray photoelectron spectroscopy study of SnO2 and SnO2+x thin films.
J. Nanosci. Nanotechnol. 13(1) , 711-3, (2013) SnO2 thin films were fabricated using low-pressure thermal chemical vapor deposition. The results of X-ray photoelectron spectroscopy revealed that the SiO2 layer with an O1S-binding energy of 531.2 eV was formed before the SnO2 layer with an O1S-binding ener... |
|
|
Effect of wastewater quality parameters on oxidation by tin oxide anodes.
Water Environ. Res. 85(2) , 151-7, (2013) The use of tin oxide anodes (TOAs) has been proposed for the disinfection of wastewater effluents and concurrent treatment of emerging contaminants. The common water quality constituents suspended solids, chemical oxygen demand (COD), alkalinity, ammonia-nitr... |
|
|
Electrochemical mineralization of pentachlorophenol (PCP) by Ti/SnO2-Sb electrodes.
Chemosphere 92(11) , 1571-7, (2013) Electrochemical degradation of pentachlorophenol (PCP) in aqueous solution was investigated over Ti/SnO2-Sb electrodes prepared by sol-gel method. X-ray diffraction (XRD), scanning electron microscopy (SEM) and electrochemical measurements were used to charac... |
|
|
SnO(2)-ZnSn(OH)(6): a novel binary affinity probe for global phosphopeptide detection.
Chem. Commun. (Camb.) 49(17) , 1762-4, (2013) ZnSn(OH)(6) and binary-component SnO(2)-ZnSn(OH)(6) were introduced as affinity probes for phosphopeptide enrichment for the first time. Two strategies, either ZnSn(OH)(6) and SnO(2) serial enrichment or binary-component SnO(2)-ZnSn(OH)(6) enrichment in a sin... |