Dipropylene glycol monomethyl ether

Dipropylene glycol monomethyl ether Structure
Dipropylene glycol monomethyl ether structure
Common Name Dipropylene glycol monomethyl ether
CAS Number 34590-94-8 Molecular Weight 148.200
Density 0.951 Boiling Point 190 ºC
Molecular Formula C7H16O3 Melting Point -80°C
MSDS Chinese USA Flash Point 166 ºF

Modeling aggregate exposures to glycol ethers from use of commercial floor products.

Int. J. Toxicol. 25(2) , 95-107, (2006)

Computer modeling of aggregate exposure provides the capability to estimate the range of doses that can occur from product use and to understand the relative importance of different routes of exposure. This paper presents an assessment of aggregate occupation...

Final report on the safety assessment of PPG-2 methyl ether, PPG-3 methyl ether, and PPG-2 methyl ether acetate.

Int. J. Toxicol. 28(6 Suppl) , 162S-74S, (2009)

PPG-2 methyl ether, PPG-3 methyl ether, and PPG-2 methyl ether acetate are used in cosmetics as fragrance ingredients and/or solvents at concentrations of 0.4% to 2%. Propylene glycol ethers are rapidly absorbed and distributed throughout the body when introd...

Critical effects and exposure limits.

Risk Anal. 17(2) , 227-36, (1997)

The use of critical effects in the determination of occupational exposure limits (OELs) in Sweden is subjected to a statistical study. Many of the present OELs are high in relation to known no-effect levels and effect levels, and the degree of protection has ...

[Anti-adhesive solutions, better knowledge for better use].

Soins. (702) , 23-7, (2006)

Contact sensitization to dipropylene glycol in an eczema population.

Contact Dermatitis 33(3) , 211-2, (1995)

Effects of textural properties on the response of a SnO2-based gas sensor for the detection of chemical warfare agents.

Sensors (Basel.) 11(7) , 6893-904, (2011)

The sensing behavior of SnO(2)-based thick film gas sensors in a flow system in the presence of a very low concentration (ppb level) of chemical agent simulants such as acetonitrile, dipropylene glycol methyl ether (DPGME), dimethyl methylphosphonate (DMMP), ...

Time-weighted average sampling of airborne propylene glycol ethers by a solid-phase microextraction device.

J. Occup. Environ. Hyg. 9(7) , 427-36, (2012)

A solid-phase microextraction (SPME) device was used as a diffusive sampler for airborne propylene glycol ethers (PGEs), including propylene glycol monomethyl ether (PGME), propylene glycol monomethyl ether acetate (PGMEA), and dipropylene glycol monomethyl e...

Dipropylene glycol monomethyl ether: a 13-week inhalation toxicity study in rats and rabbits.

Fundam. Appl. Toxicol. 4(4) , 612-7, (1984)

Fischer 344 rats (10/sex/exposure concentration) and New Zealand White rabbits (7/sex/exposure concentration) were exposed to 0, 15, 50, or 200 ppm (0, 91, 303, or 1212 mg/m3) of dipropylene glycol monomethyl ether (DPGME) for 6 hr/day, 5 days/week for 13 wee...

Array of Love-wave sensors based on quartz/Novolac to detect CWA simulants.

Talanta 85(3) , 1442-7, (2011)

An array of Love-wave sensors based on quartz and Novolac has been developed to detect chemical warfare agents (CWAs). These weapons are a risk for human health due to their efficiency and high lethality; therefore an early and clear detection is of enormous ...

Detection thresholds for phenyl ethyl alcohol using serial dilutions in different solvents.

Chem. Senses 28(1) , 25-32, (2003)

Detection thresholds are typically obtained by presenting a subject with serial dilutions of an odorant. Many factors, including the solvent used to dilute the odorant, can influence the measurement of detection thresholds. Differences have been reported in d...