氢化钾结构式
|
常用名 | 氢化钾 | 英文名 | potassium hydride |
---|---|---|---|---|
CAS号 | 7693-26-7 | 分子量 | 39.09830 | |
密度 | 1.45 | 沸点 | 316ºC | |
分子式 | K+ | 熔点 | N/A | |
MSDS | 中文版 美版 | 闪点 | 113ºC | |
符号 |
GHS02, GHS05 |
信号词 | Danger |
氢化钾用途用作有机合成的缩合剂及烷化剂。 |
中文名 | 氢化钾 |
---|---|
英文名 | potassium hydride |
英文别名 | 更多 |
密度 | 1.45 |
---|---|
沸点 | 316ºC |
分子式 | K+ |
分子量 | 39.09830 |
闪点 | 113ºC |
精确质量 | 38.96370 |
外观性状 | dispersion (in mineral oil (~35%)) |
储存条件 | 储存注意事项储存于阴凉、干燥、通风良好的专用库房内,远离或中偶那个、热源。库温不超过32℃,相对湿度不超过75%。包装密封。应与氧化剂、酸类、醇类、卤素等分开存放,切忌混储。采用防爆型照明、通风设施。禁止使用易产生火花的机械设备和工具。储区应备有合适的材料收容泄漏物。 |
稳定性 | 1.稳定性不稳定 2.禁配物水、醇类、酸类、强氧化剂、氯代烃、卤素、氧、空气 3.避免接触的条件潮湿空气、受热 4.聚合危害不聚合 |
分子结构 | 1、摩尔折射率:无可用的 2、摩尔体积(cm3/mol):无可用的 3、等张比容(90.2K):无可用的 4、表面张力(dyne/cm):无可用的 5、介电常数:无可用的 6、极化率(10-24cm3):无可用的 7、单一同位素质量:39.971532 Da 8、标称质量:40 Da 9、平均质量:40.1062 Da |
计算化学 | 1.疏水参数计算参考值(XlogP):无 2.氢键供体数量:0 3.氢键受体数量:0 4.可旋转化学键数量:0 5.互变异构体数量:无 6.拓扑分子极性表面积0 7.重原子数量:1 8.表面电荷:0 9.复杂度:0 10.同位素原子数量:0 11.确定原子立构中心数量:0 12.不确定原子立构中心数量:0 13.确定化学键立构中心数量:0 14.不确定化学键立构中心数量:0 15.共价键单元数量:2 |
更多 | 1.性状:白色针状结晶,商品为灰色粉末,半分散于油中。 2.熔点(分解,℃):316 3.相对密度(水=1):1.43~1.47 4.溶解性:不溶于液氨、二硫化碳。 |
|
氢化钾毒理学数据: 1、急性毒性: LD50:4000mg/Kg(大鼠经口);4720mg/Kg(兔经皮) LC50:9400mg/m3,2小时(小鼠吸入) 氢化钾生态学数据: 对水是稍微危害的,若无政府许可,勿将材料排入周围环境。 |
符号 |
GHS02, GHS05 |
---|---|
信号词 | Danger |
危害声明 | H260-H314 |
补充危害声明 | Reacts violently with water. |
警示性声明 | P231 + P232-P260-P280-P305 + P351 + P338-P370 + P378-P402 + P404 |
个人防护装备 | Faceshields;full-face respirator (US);Gloves;Goggles;multi-purpose combination respirator cartridge (US);type ABEK (EN14387) respirator filter |
危害码 (欧洲) | F:Highlyflammable;C:Corrosive; |
风险声明 (欧洲) | R11;R14/15;R34 |
安全声明 (欧洲) | S16-S26-S36/37/39-S43-S45-S7/8 |
危险品运输编码 | UN 1409 4.3/PG 1 |
WGK德国 | 3 |
包装等级 | I |
危险类别 | 4.3 |
~% 氢化钾 7693-26-7 |
文献:Journal of Chemical Physics, , vol. 110, # 14 p. 6743 - 6748 |
氢化钾上游产品 2 | |
---|---|
氢化钾下游产品 0 |
制备氢化锂的氢化装置。
1:石英管;2:无缝钢管;3:铁制小舟;4:一端封闭的铁制圆筒。
使用之前要除去1、2、3表面上的氧化物,为此可将装置抽真空,并从5通入电解氢并用电炉长时间加热。氢气应经过五氧化二磷干燥剂的预处理。
所需的金属钾应在二甲苯中熔融数次,以除去附着其上的石蜡油或高沸点烃类。首先通入H2将空气赶尽,保持101.3kPa(1atm)的H2。将表面光洁的金属钾放在舟3中,套入圆筒4,再放入无缝钢管2中,装入管1。加热石英管至300~400℃,使金属钾徐徐蒸发,此时即有细微的针状结晶沉积在加热炉两旁。在进行反应的一天中H2气流始终保持101.3kPa(1atm)。当压力计式的活门7指示管中的压力不再降低时,即打开管口6,在氢气流中用铂铲将生成的氢化物刮到管8中,从磨口9处将管1拆下,塞住。从10处取口氢化钾,放入密封瓶中保存。
The influence of surface charge and photo-reactivity on skin-permeation enhancer property of nano-TiO₂ in ex vivo pig skin model under indoor light.
Int. J. Pharm. 467(1-2) , 90-9, (2014) Several topical products contain nanometric TiO2 (nano-TiO2), which is a useful and safe component that absorbs UV light and does not cross skin barrier. However, nano-TiO2 may impregnate the first la... |
|
Molecular insights into shellac film coats from different aqueous shellac salt solutions and effect on disintegration of enteric-coated soft gelatin capsules.
Int. J. Pharm. 484(1-2) , 283-91, (2015) The purpose of this investigation was to study the effect of using different salts of shellac on the disintegration properties of shellac-based enteric coatings. In the last two decades, shellac has b... |
|
Study on the phase I metabolism of novel synthetic cannabinoids, APICA and its fluorinated analogue.
Drug Test. Anal. 7(2) , 131-42, (2015) The data are reported for an in vitro metabolism study of two novel synthetic cannabinoids, N-(1-adamantyl)-1-pentyl-1H-indole-3-carboxamide (APICA) and its fluorinated analog N-(1-adamantyl)-1-(5-flu... |
Potassium hydride |
potassium,hydride |
MFCD00011357 |
EINECS 231-704-8 |