External ID: TargetID_659_CEMA

Protocol: Black, standard capacity streptavidin-coated 384-well plates (Pierce 15407) were first washed with 50 L of phosphate buffer (100 mM, pH 7.0; PB7) three times using a Biotek 405 ELX plate washer. Subsequently, 5 L of biotinylated pre-miRNA substrate (500 nM final) was dispensed into the plate using a Multidrop Combi Reagent Dispenser (Thermo Scientific). Plates were then centrifuged for 1 min at 1,000 RPM (223 g), sealed with plate tape, and incubated overnight at 4 C. The following morning, plates were washed three times with 50 L of PB7, followed by the addition of 5 L of Dicer digest buffer (20 mM Tris, 12 mM NaCl, 2.5 mM MgCl2, 1 mM fresh DTT, and 4.5% DMSO) and centrifugation. Compounds (50 nL of 5 mM DMSO stock, 25 M final) were then added into the sample wells using a Sciclone (Caliper) liquid handler with V&P pintool; the same volume of DMSO was added to the control wells. The plates were incubated at 25 C for 15 min before addition of 5 L of digest buffer containing 217 g/nL Dicer (108 g/mL Dicer, 5% glycerol and 0.01% Triton X-100 final, excess with respect to pre-miRNA). For the positive control wells, digest buffer without Dicer was added. The plates were centrifuged again and resealed before being placed in a 37 C incubator for 5 h. After Dicer cleavage, plates were washed three times with 50 L of PB7. mTet-HRP in PB7 (10 L, 750 nM final) was then dispensed into each well. The plates were subsequently centrifuged, sealed, and incubated at 25 C for 2 h. Plates were then washed three times with 50 L of wash buffer (2 mM imidazole, 260 mM NaCl, 0.5 mM EDTA, 0.1% Tween-20, pH 7.0), followed by washing three additional times with 50 L of PB7. Finally, SuperSignal West Pico (25 L; Pierce) was added, the plates were incubated at 25 C for 5 min, and chemiluminescence signal was detected using a PHERAstar plate reader using LUM plus module (BMG Labtech).

Comment: The activity outcome is based on a Z-score (number of standard deviations from the negative control mean) of 3 or higher on at least 50% times that the sample was screened.

For instance, if the sample was screened in n=4 runs, it would be considered active only if it had a Z-score of 3 or above in at least 2 runs.

External ID: RMI-FANCM-MM2

Protocol: FP HTS. Screening took place at the University of Wisconsin Small Molecule Screening and Synthesis Facility. A master mix of RMI core complex and F-MM2 (30 microL per well) was plated in black 384 shallow well plates (ThermoFisher, Waltham, MA), using a BioTek "MicroFlo Select" reagent dispenser. Compounds were added using a Beckman FX liquid handler; 0.33 microL of 10 mM stock was added for a final compound concentration of 33 microM. MM2 and cMM2 were each added to 4 wells of master mix per plate to a final concentration of 10 muM to serve as controls. Following compound addition, plates were covered, centrifuged briefly, and incubated for 20 minutes at room temperature. FP measurements were taking using a Tecan "Safire 2" microplate reader. Instrument settings were as follows: top read, EX 470, EM 525/20, G-factor 0.89947. A suitable gain was calculated from the first plate of each day. Z' scores for were calculated for each plate; plates with Z' scores <0.5 were rerun prior to analysis.

Comment:

External ID: MCF7_OneDose

Protocol: NCI-60 Human Tumor Cell Lines Screen was performed using the standard one-dose NCI protocol, which is described in more detail at https://dtp.cancer.gov/discovery_development/nci-60/default.htm.

Compounds with GIPRCNT values below 10 were considered active. Activity score was based on GIPRCNT using the following formula:
max(-GIPRCNT/2 + 50, 0)
Score is 0 for GIPRCNT values of 100 or above, 50 for GIPRCNT values of 0, and 100 for GIPRCNT values of -100.

Comment: These data are a subset of the data from the NCI human tumor cell line screen. Compounds are identified by the NCI National Service Center (NSC) number, which is contained in the
PUBCHEM_EXT_DATASOURCE_REGID field. In the NCI cell line identification system, MCF7 is panel number 5, cell number 1. PANELCODE or PANELNAME identify the NCI-60 cell panel. PANELNBR does NOT identify the NCI-60 panel.

EXPID is the NCI internal tracking number for the experiment identifier, and PREFIX = 'S' for the NSCs submitted through the NCI Chemical Agents repository.

Substance concentration unit is indicated in the data table, using the following abbreviations: M = molar (M), u = micrograms/milliliter (microg/mL), V = volumetric fraction.

M_GIPRCNT represents the mean growth percent for that experiment, and N_GIPRCNT indicates the number of values for that NSC within an experiment, while STDEV_GIPRCNT is the standard deviation. Most NSCs are tested once per experiment, resulting in EXP_COUNT = 1.

External ID: CHEMBL2319315

Protocol: N/A

Comment: Compounds with activity <= 10uM or explicitly reported as active by ChEMBL are flagged as active in this PubChem assay presentation.

Journal: J. Med. Chem.
Year: 2013
Volume: 56
Issue: 3
First Page: 952
Last Page: 962
DOI: 10.1021/jm3014162

Target ChEMBL ID: CHEMBL2029198
ChEMBL Target Name: Rap guanine nucleotide exchange factor 4
ChEMBL Target Type: SINGLE PROTEIN - Target is a single protein chain
Relationship Type: D - Direct protein target assigned
Confidence: Direct single protein target assigned

External ID: MScreen:TargetID_600

Protocol: C-terminally 6xHis tagged CDK2/Cyclin A complex and N-terminally Flag tagged CDC25B C473S (372-566) were expressed and purified. Proteins were incubated together at a final concentration of 125 nM each for 1 hr prior to incubation with compound for 1 hr, followed by addition of anti-6xHis europium cryptate donor beads (Cisbio) and anti-Flag XL-665 acceptor beads (Cisbio) at a final dilution of 1:350 for 1 hr. 20mM potassium fluoride was added 10 minute prior to plate reading. Assay reagents were dispensed using a multidrop liquid dispenser (Thermo Scientific) onto uncoated, black, low-volume, 384-well plates (Corning). Assay plates were quantified using an Envision plate reader (Perkin-Elmer) with excitation of the europium crytate donor at 337 nm wavelength and emission of the donor at 620 nm and emission of the XL-665 acceptor at 665 nm in 18 uL volumes. Assays were performed in a buffer containing 50 mM Tris (pH 7.5), 50 mM NaCl, 10mM MgCl2, 1mM TCEP, with addition of and 1mM ATP, 0.05% BSA, and 0.05% Tween-20 immediately prior to the start of the assay.

Comment: The activity outcome is based on a Z-score (number of standard deviations from the negative control mean) of 3 or higher on at least 50% times that the sample was screened.
For instance, if the sample was screened in n=4 runs, it would be considered active only if it had a Z-score of 3 or above in at least 2 runs.

This screen was funded by NIH grant number: R01CA181185

External ID: CHEMBL1024483

Protocol: N/A

Comment: Journal: Bioorg. Med. Chem.
Year: 2009
Volume: 17
Issue: 9
First Page: 3352
Last Page: 3368
DOI: 10.1016/j.bmc.2009.03.040

Target ChEMBL ID: CHEMBL399
ChEMBL Target Name: HeLa
ChEMBL Target Type: CELL-LINE - Target is a specific cell-line
Relationship Type: N - Non-molecular target assigned
Confidence: Target assigned is non-molecular

External ID: CHEMBL1024480

Protocol: N/A

Comment: Compounds with activity <= 10uM or explicitly reported as active by ChEMBL are flagged as active in this PubChem assay presentation.

Journal: Bioorg. Med. Chem.
Year: 2009
Volume: 17
Issue: 9
First Page: 3352
Last Page: 3368
DOI: 10.1016/j.bmc.2009.03.040

Target ChEMBL ID: CHEMBL4372
ChEMBL Target Name: Anthrax lethal factor
ChEMBL Target Type: SINGLE PROTEIN - Target is a single protein chain
Relationship Type: D - Direct protein target assigned
Confidence: Direct single protein target assigned

External ID: KUHTS-Muma KU-CaM-Htt INH-01

Protocol: 1; Dispense 45 nl compounds (10 mM stocks) using ECHO 555 to Alpha 384 well assay plates. Dispense 45 nl DMSO to control columns 1 and 2 of 384 well plates.
2; Incubate 5 ul of 6XHis-mHTT (Final, 13 nM) with the compounds for 40 mins at room temperature in buffer containing 10 mM Tris.HCl pH 7.4, 1 mM calcium chloride, 150 mM sodium chloride, 0.1% BSA and 20% glycerol.
3; Dispense 5 ul of 6XGST-CaM (Final 13 nM) in buffer A.
4; Incubation; 1 hour (dark at 25C)
5; Dispense 20 ul of Nickel chelate acceptor beads (Final, 20 ugs/ml) and Glutathione donor beads (Final, 30 ugs/ml). Incubate for 2h, room temperature.
6; Detector: Perkin Elmer Enspire, Alphascreen Module (Excitation 680nm/Emission 570nm).

NOTES (numbers refer to Sequence numbers above)
1. Alphascreen bead incubations were performed in green light, TiterTek setting 400rpm.
2. All incubation and addition steps were followed by mixing and centrifugation at 400g,1 min.
3. The percent inhibition for each compound was calculated as follows:
100- [100 *((Test Compound-Median Low Control) / (Median High Control - Median Low Control))]

Where:
Test_Compound is defined as wells containing His mHTT + GST CaM in the presence of test compound

High_Control is defined as wells containing His mHTT + GST CaM and DMSO.

Low_Control is defined as wells containing His mHTT and DMSO.

Comment: All percent inhibition data reported were normalized to high and low controls on a per-plate basis. The results of primary screening data include compounds contributing to assay signal interference, interference with tags binding to Alpha beads, chelators, process related artifacts etc.. The actives were defined as compounds that inhibited Alphascreen reads to greater than 50%.

External ID: CHEMBL2319316

Protocol: N/A

Comment: Journal: J. Med. Chem.
Year: 2013
Volume: 56
Issue: 3
First Page: 952
Last Page: 962
DOI: 10.1021/jm3014162

Target ChEMBL ID: CHEMBL2029198
ChEMBL Target Name: Rap guanine nucleotide exchange factor 4
ChEMBL Target Type: SINGLE PROTEIN - Target is a single protein chain
Relationship Type: D - Direct protein target assigned
Confidence: Direct single protein target assigned