External ID: HMS1262

Protocol: NEC is stored at -80 degrees at a concentration of 15mg/ml in single use aliquots.

On the day of the screen, 20ul of purified NEC is aliquoted using a Multidrop Combi reagent dispenser into 384 well plates (Corning 3824). 100nl of compound dissolved in DMSO was transferred to each well of the assay plated via pin transfer. The plates (NEC + compound) are incubated at room temperature for 3 hours. Acceptor and donor reagents (CisBio 620/665 pair) are combined then added to each well at 5 microL volumes at a concentration of 8 nM and 80nM respectively. The plates are spun at 1k rpm for 1 min and incubated overnight at 4 degrees, then for one hour the subsequent day at room temperature.

Flourescent measurements are read on the Envision 1 plate reader at ICCB-L. The raw data consists of two fluorescence readings - at 665 nm and 620 nm for the acceptor and donor respectively.

Comment: Data analysis:
The raw data consists of two fluorescence readings - at 665 and 620 nm for the acceptor and donor respectively. The data is processed as a ratio of the emission from the acceptor over the donor (homogeneous time resolved fluorescence ratio). Normalized percent inhibition (NPI) for all experimental wells is calculated based on plate averages for negative and positive control HTRF ratio. Positives are scored as any ratio with a 50% or greater inhibition as compared with the positive control (i.e. NEC + Untagged UL50). To be considered a hit, both replicates need to score as positive. Activity scores are derived from NPI, with 100 = 100% inhibition (> 100% set to 100) and 0 = no inhibition (< 0% set to 0). Note that some compounds with NPI <50% (activity scores < 50) are classified as potential hits based on additional criteria (typically by selecting wells with low ratios compared to other experimental wells on the plate).