External ID: HMS1262

Protocol: NEC is stored at -80 degrees at a concentration of 15mg/ml in single use aliquots.

On the day of the screen, 20ul of purified NEC is aliquoted using a Multidrop Combi reagent dispenser into 384 well plates (Corning 3824). 100nl of compound dissolved in DMSO was transferred to each well of the assay plated via pin transfer. The plates (NEC + compound) are incubated at room temperature for 3 hours. Acceptor and donor reagents (CisBio 620/665 pair) are combined then added to each well at 5 microL volumes at a concentration of 8 nM and 80nM respectively. The plates are spun at 1k rpm for 1 min and incubated overnight at 4 degrees, then for one hour the subsequent day at room temperature.

Flourescent measurements are read on the Envision 1 plate reader at ICCB-L. The raw data consists of two fluorescence readings - at 665 nm and 620 nm for the acceptor and donor respectively.

Comment: Data analysis:
The raw data consists of two fluorescence readings - at 665 and 620 nm for the acceptor and donor respectively. The data is processed as a ratio of the emission from the acceptor over the donor (homogeneous time resolved fluorescence ratio). Normalized percent inhibition (NPI) for all experimental wells is calculated based on plate averages for negative and positive control HTRF ratio. Positives are scored as any ratio with a 50% or greater inhibition as compared with the positive control (i.e. NEC + Untagged UL50). To be considered a hit, both replicates need to score as positive. Activity scores are derived from NPI, with 100 = 100% inhibition (> 100% set to 100) and 0 = no inhibition (< 0% set to 0). Note that some compounds with NPI <50% (activity scores < 50) are classified as potential hits based on additional criteria (typically by selecting wells with low ratios compared to other experimental wells on the plate).

External ID: MCF7_OneDose

Protocol: NCI-60 Human Tumor Cell Lines Screen was performed using the standard one-dose NCI protocol, which is described in more detail at https://dtp.cancer.gov/discovery_development/nci-60/default.htm.

Compounds with GIPRCNT values below 10 were considered active. Activity score was based on GIPRCNT using the following formula:
max(-GIPRCNT/2 + 50, 0)
Score is 0 for GIPRCNT values of 100 or above, 50 for GIPRCNT values of 0, and 100 for GIPRCNT values of -100.

Comment: These data are a subset of the data from the NCI human tumor cell line screen. Compounds are identified by the NCI National Service Center (NSC) number, which is contained in the
PUBCHEM_EXT_DATASOURCE_REGID field. In the NCI cell line identification system, MCF7 is panel number 5, cell number 1. PANELCODE or PANELNAME identify the NCI-60 cell panel. PANELNBR does NOT identify the NCI-60 panel.

EXPID is the NCI internal tracking number for the experiment identifier, and PREFIX = 'S' for the NSCs submitted through the NCI Chemical Agents repository.

Substance concentration unit is indicated in the data table, using the following abbreviations: M = molar (M), u = micrograms/milliliter (microg/mL), V = volumetric fraction.

M_GIPRCNT represents the mean growth percent for that experiment, and N_GIPRCNT indicates the number of values for that NSC within an experiment, while STDEV_GIPRCNT is the standard deviation. Most NSCs are tested once per experiment, resulting in EXP_COUNT = 1.

External ID: IGROV1_OneDose

Protocol: NCI-60 Human Tumor Cell Lines Screen was performed using the standard one-dose NCI protocol, which is described in more detail at https://dtp.cancer.gov/discovery_development/nci-60/default.htm.

Compounds with GIPRCNT values below 10 were considered active. Activity score was based on GIPRCNT using the following formula:
max(-GIPRCNT/2 + 50, 0)
Score is 0 for GIPRCNT values of 100 or above, 50 for GIPRCNT values of 0, and 100 for GIPRCNT values of -100.

Comment: These data are a subset of the data from the NCI human tumor cell line screen. Compounds are identified by the NCI National Service Center (NSC) number, which is contained in the
PUBCHEM_EXT_DATASOURCE_REGID field. In the NCI cell line identification system, IGROV1 is panel number 6, cell number 10. PANELCODE or PANELNAME identify the NCI-60 cell panel. PANELNBR does NOT identify the NCI-60 panel.

EXPID is the NCI internal tracking number for the experiment identifier, and PREFIX = 'S' for the NSCs submitted through the NCI Chemical Agents repository.

Substance concentration unit is indicated in the data table, using the following abbreviations: M = molar (M), u = micrograms/milliliter (microg/mL), V = volumetric fraction.

M_GIPRCNT represents the mean growth percent for that experiment, and N_GIPRCNT indicates the number of values for that NSC within an experiment, while STDEV_GIPRCNT is the standard deviation. Most NSCs are tested once per experiment, resulting in EXP_COUNT = 1.

External ID: WaveGuideAssay:441

Protocol: For initial screening, TetON human embryonic kidney cells (HEK293) expressing GluA2 and stargazin, gamma-2, were plated in 384-well BD purecoat amine-coated plates at 16k cells/well. Cells were induced with 8 ug/mL doxycycline in the presence of 30 uM NBQX and incubated O/N at 37deg in 5% CO2. They were washed with Hank's Balanced Salt Solution (HBSS) containing 20 mM HEPES, pH 7.4 and FLIPR VSD dye solution was added and incubated on the cells at room temperature for 45 minutes. The cell plate was loaded into the Hamamatsu Functional Drug Screening System 6000 (FDSS), 10 seconds of background were collected before addition of compound at 30 uM final concentration. Data collection continued at 1Hz sampling and experimentally determined EC50 glutamate stimulus was added at 300 seconds. Controls of 1 mM glutamate (maximal effect) and NBQX (antagonist) were used to calculate a Z' score per plate.

Data were processed using the Vanderbilt screening analysis platform, WaveGuide. Data were normalized by dividing the raw fluorescence for all time points by an average of the baseline fluorescence. For each well, 4 values were calculated as follows:

1. CMPDslope was the slope of the normalized value within the timeframe 11-18 seconds,
2. CMPDmaxmin was the difference in maximal and minimal normalized value within the timeframe 8-100 seconds
3. GLUslope was the slope of the normalized value within the timeframe 310-315 seconds, and
4. GLUmaxmin was the difference in maximal and minimal normalized value within the timeframe 301-380 seconds.

Compounds were marked as hits where any of the above calculated results for a compound differed by at least three standard deviations from the mean for that calculation across all compounds in the plate.

Compounds denoted as 'hits' were given the score of '100' and outcome of 'active'. All other compounds were denoted as 'inactive' and given a score of '0'.

Comment:

External ID: VANDERBILT_HTS_GIRK2_MPD

Protocol: To screen for modulators of the G protein-gated inwardly-rectifying potassium channel subunit 2 (GIRK2) homomeric channels, HEK293 cells were engineered to overexpress GIRK2. These cells were screened using a high-throughput thallium-flux assay in a 384-well format. High-throughput thallium flux assays are based on three principles: (1) extracellular thallium can permeate through potassium channels into cells, (2) the fluorescent dye Thallos enters and stays in the cytoplasm of HEK293 cells, and (3) the fluorescence of Thallos increases dramatically when it interacts with thallium ions. Compounds that modulate the activity of an overexpressed channel, in this case GIRK2, are identified by the change in fluorescence that results from changes in thallium influx into cells through the overexpressed channel.

The screening protocol was conducted as follows. One hour prior to screening, cells were loaded with 1.5 micromolar (muM) Thallos in assay buffer (1x Hank's Balanced Salt Solution and 20 millimolar (mM) HEPES). The liquid handling and imaging was conducted using a kinetic-imaging plate reader, Panoptic (WaveFront Biosciences). Before screening, Thallos-containing buffer was removed from cells and replaced with 20 microliters (muL) per well of assay buffer. Compounds were dissolved in assay buffer at 20 muM. After 8 seconds of imaging, 20 muL of compound solution was added per well and allowed to incubate for 150 seconds. Next, 10 muL of a solution containing 2.0 mM thallium in Base Buffer (125 mM NaHCO3, 1 mM MgSO4, 1.8 mM CaSO4, 5mM Glucose, and 20 mM HEPES) was added to the wells. 30 seconds later, 12 muL of base buffer containing 2.0 mM thallium and 50 mM 2-methyl-2,4-pentanediol (MPD), a partially-activating concentration, was added to each well. MPD has is a previously-described GIRK2 channel activator. Data was collected for 60 seconds after this final addition. The positive control for this screen was 30 muM ivermectin, a natural product previously identified as a GIRK2 activator as part of a small-scale pilot screen. Microsoft Excel was utilized for data analysis. Data were normalized, F/Fo, on a well-to-well basis to account for differences in cell number. Compound activity was analyzed by comparing the sums of control-subtracted amplitudes of fluorescence intensity at 20 seconds after each thallium addition. The top 0.2% compounds corresponding to wells that demonstrated the largest increases in fluorescence were selected as "hits" for counter screening, as described below.

All 63,228 compounds screened using the method described above are listed in column OUTCOME_SCREEN_HITS. The 133 compounds selected as hits based on the above criteria are labelled with "100" in the ACTIVITY column. Fluorescent compounds were included in the inactive compounds and marked with "0" in the ACTIVITY column.

The 133 active compounds from column OUTCOME_SCREEN_HITS were tested for non-specific activity in untransfected HEK293 cells using assay conditions otherwise identical to the primary screen. Column OUTCOME_HEK_COUNTERSCREEN lists the 23 compounds that displayed an increase in fluorescence upon thallium addition with "100" in the ACTIVITY column.

The 110 compounds which were identified as hits in the primary screen but inactive when tested in untransfected HEK293 cells were tested for activity in GIRK2-overexpressing HEK293 cells that did not express NPY4 receptor. Column OUTCOME_GIRK2_COUNTERSCREEN lists the 44 compound that displayed an increase in fluorescence upon thallium addition with "100" in the ACTIVITY column.

The 44 active compounds from column OUTCOME_GIRK2_COUNTERSCREEN were tested at various concentrations to determine if compound activity was concentration dependent. Column OUTCOME_GIRK2_DOSE_RESPONSE provides the efficacy of these compounds; activity of all compounds at the provided concentrations was normalized to the activity of VU0537695 at 25 muM, which was the highest efficacy observed during this screening. For each compound concentration listed, the efficacy of that compound provided refers to the normalized, control-subtracted fluorescence intensity at 15 seconds after the addition of thallium. The 28 compounds that demonstrated >5% efficacy and concentration-dependent activity were labelled as "100" in the ACTIVITY column.

Finally, column PUBCHEM_ACTIVITY_OUTCOME combines all of the information from the above counterscreens together, indicating the 28 hits from this GIRK2 screen.

Comment: