An improved method for ratiometric fluorescence detection of pH and Cd2+ using fluorescein isothiocyanate-quantum dots conjugates.

Rijun Gui, Xueqin An, Wenxue Huang

Index: Anal. Chim. Acta 767 , 134-40, (2013)

Full Text: HTML

Abstract

In this study, thioglycolic acid capped-CdTe quantum dots (QDs) were modified by polyethylenimine (PEI), and then combined with fluorescein isothiocyanate (FITC) to fabricate FITC-CdTe conjugates. The self-assembly of FITC, CdTe and PEI was ascribed to electrostatic interactions in aqueous solution. The resulting conjugates were developed toward two routes. In route one, ratiometric photoluminescence (PL) intensity of conjugates (IFITC/IQDs) was almost linear toward pH from 5.3 to 8.7, and a ratiometric PL sensor of pH was favorable obtained. In route two, firstly added S(2-) induced remarkable quenching of QDs PL peak (at the "OFF" state), which was restored due to following addition of Cd(2+) (at the "ON" state). In the conjugates, successive introduction of S(2-) and Cd(2+) hardly influenced on FITC PL peaks. According to this PL "OFF-ON" mode, a ratiometric PL method for the detection of Cd(2+) was achieved. Experimental results confirmed that the IFITC/IQDs exhibited near linear proportion toward Cd(2+) concentration in the range from 0.1 to 15μM, and the limit of detection was 12nM. Interferential experiments adequately testified that the proposed sensors of pH and Cd(2+) were practicable in real samples and complex systems. In comparison with conventional analytical techniques, the ratiometric PL method was simple, rapid, economic and highly selective.Copyright © 2013 Elsevier B.V. All rights reserved.